Sankosha finishing equipment is widely
recognised as the world leader in supplying the finest quality shirt
finishing systems and air operated garment presses.
Their reliability is second-to-none which is why they supply all their
equipment with a 5 year warranty for all welded parts and their
microprocessors.
Exceptional productivity is maintained with the highest possible quality
produced shirt after shirt, without the need for additional post ironing.
Training on new equipment for shirt finishing is achieved in only a few
hours with superb results produced time after time.
New designed model launched
August 2005
Double Buck Shirt Press CF-161E
New designed model launched August 2006
Double Rotary Collar Cuff Press
LP-360E
Each station finishes two sets of shirts at a time on the Double
Rotary Collar Cuff
Press CF-360E.
This can be geared up to keep up with the production of 2 x CF-161E
double buck body units.
This amount of production is un-rivalled in any
other system.
Single Buck Shirt Press CN-567E
Single Collar Cuff LP-660E
The Collar Cuff LP-660E is
also designed to press short sleeves or can be used as a flat work
station.
Single Tensioning Collar Cuff Press LP-690E
New designed model launched August 2006
Single Rotary Collar Cuff Press
LP-300E
The latest new product to come from
Sankosha is their LP-300E which is capable of finishing one shirt whilst
another is being loaded or unloaded, allowing sufficient production to
feed either two x CN-567E Single buck presses or 1 x CF-161E Double buck
shirt press.
Shirt Body Finishing System DF-550E
Designed for
finishing shirt body and to finish the largest shirt sizes 14.5 - 17.
Computer controlled operation with most controls located on the front
clamp. Foot pedal start. 3 factory set programmes for instant change
from wet to dry shirt processing. Automatic tail clamp detection by
sensor. Automatic tail clamp stretching during cycle. Short
sleeves finishing facility by easily rotating the cuff clamps from long
sleeve horizontal position. Automatic shirt tensioning, with 3 factory
set modes for strong, weak or no tensioning. Manual sleeve tensioning
adjustment possible during cycle operation. Powerful steam injection
into the sleeves during the cycle to remove any creasing 0.175 Kg/second .
Cycle extendable by 10 seconds during operation by simply pressing foot
pedal, or for immediate ending of cycle press blue button on front clamp.
For central steam supply
Shirt Body Finishing System DF-550E
Rotary Form Finisher DF-050E
Trouser Topper DF-740E-N
The Sankosha Jacket Form Finisher is the everything to
anybody. Able to process from Jackets to Jumpers.
The Trouser Topper with leg stretch produces perfect
results using "switch on" "switch off" stretch down
system..